TC-PRO cable can significantly improve stability, speed and the overall performance of Ethernet cable connections.
The cables are designed to work even in the most difficult weather conditions.
Effective protection of networks against the destructive effects of electrostatic discharge (ESD).
The TOUGHCable has been developed to increase performance for power transmission for extended cable sections.
| Features / filters | |
| Cabel for assembly | Outside the building |
| Cable category | Cat.5e |
| Length | 305m |
| Shielding type | SF/UTP |
| AWG wire size | 24 |
| Cable length | 304.8 |
| Cable standard | Cat5e |
| Cable top coat | PE |
| Cable type | Installation cables |
| Certification | ISO/IEC 11801, TIA/EIA568B.2 |
| Conductor type | Solid |
| Connector 1 | No |
| Connector 2 | No |
| Connector contacts plating | Copper |
| Data transfer rate | 1000 |
| Jacket material | Polyethylene (PE) |
| Product colour | Black |
| Basic technical parameters | |
| Type of cable | CAT5e, shielded |
| Capacity | Up to 1 Gbps |
| Conductor Wire Gauge | 24 AWG |
| Conductor | Copper |
| Conductor diameter | 0.500 ± 0.005 mm |
| Type of insulation | PE |
| Insulation thickness | Average 0.26 mm, minimum 0.25 mm |
| Insulation diameter | 1.04 ± 0.03 mm |
| Cable shielding (Aluminium foil) | Thickness: 0.060 mm, Width: 18 mm |
| ESD drain wire | 0.4 CCS |
| Rip Cord | Yes |
| Jacket material | PE |
| Jacket thickness | Average 0.50 mm, minimum 0.46 mm |
| Jacket outer diameter | 6.0 ± 0.30 mm |
| Colour | Black |
| Certificates | ISO/IEC 11801, THIA/EIA568B.2 |
| Installation temperature | -20 to 60° C |
| Storage temperature | -30 to 75° C |
| Operating temperature | -40 to 80° C |
1. Use a TOUGHCable Connector to gauge how much of the jacket to strip (roughly 22 mm). Mark the appropriate length and strip the necessary length of cable jacket with wire strippers.
2. Carefully fold back the foil shield to expose the drain wire and twisted pair cable.
3. Carefully fold back the drain wire.
4. Cut or tear away the clear plastic wrapping around the twisted pair cable and untwist the wires that are exposed.
5. Place the wires in order as shown below, ensure the wires are as straight and compact as possible.
6. Use wire cutters to trim the ends of the wires evenly to ensure a straight surface to insert into the TOUGHCable Connector.
7. Fold the foil shield back up towards the exposed wires, leaving roughly half the distance exposed while covering the bottom half with the foil. Fold back any excess foil.
8. Keeping the wires in the correct order, mold the foil firmly around the covered portion of wires and insert the wires carefully into the TOUGHCable Connector.
9. Place the TOUGHCable Connector and twisted pair cable into the cable crimper and press firmly.
10. Feed the exposed portion of drain wire through the drain wire hook on the outside of the connector and fold it over. 
11. Crimp the drain wire hook with a pair of needle-nose pliers to create a secure contact between the drain wire and hook. 
12. Repeat steps 1-11 for the other end of the cable.
