EN
Yeastar TG400 is a digital VoIP-GSM gateway with support for up to four SIM cards. With this device you can significantly reduce the cost of communication in your company, and also connect your phone number wherever the signal from mobile operators reaches. Voip gateways Yeastar neogate tg400 ip pbx is a voip gsm device, in which you can specify m.In sms sending, network attack alertli, sip accounts, real open api protocol, caller idclirli, sms and ussdli, carrier selection automanual, sip peer mode, ip dhcp client firewall vlan, static nat, bulk sms, gsm network operators, gsm gateways, static ip, dhcp client firewall vlan ddns, static ip dhcp client firewall, calling type, call duration limitation, sending bulk, call duration, call status, unified communications. Gsm gateways have easy configuration by entering basic parameters. TG400 voip is an ideal solution for both small businesses and large call centers. Delivery costs are specified in the shop regulations and vary depending on the size of an order
Yeastar TG400 works as follows: after installing SIM cards and connecting to the local network, it can be registered to any modern IP-PBX that supports SIP or IAX2 protocols. It is also possible to abandon the use of stations and register IP phones directly to a GSM gateway. This solution slightly limits the functionality of the system, but allows to save on hardware.
In addition to full voice support (making and receiving calls over GSM lines), Yeastar TG400 has extensive SMS messaging capabilities. In particular, it supports sending and receiving messages from a web interface, bulk messaging, as well as custom configuration using an open API.
Basic general data | |
Manufacturer | Yeastar |
Model | TG400 |
Type | VoIP-GSM gateway |
Interfaces | 4 x GSM or 3G or 4G channels 1 x 10/100 Mbps Ethernet Interface |
Voice processing | |
Minutes | SIP, IAX2 |
Transport | UDP, TCP, TLS, SRTP |
Voice codec | G.711 (alaw/ulaw), G.722, G.726, G.729A, GSM, ADPCM, Speex |
Echo correction | ITU-T G.168 LEC |
DTMF mode | RFC2833, SIP INFO, In-band |
Included SIP server for IP phones SIP answer code switch Call progress tone generation 1-step/2-step dialing |
|
System features | |
Mobile port groups VoIP Trunk group Incoming / outgoing routing rules Blacklist Hotline AutoCLIP Call duration restriction Call transfer Callback Call Detail Recording (CDR) Call status display NTP IP blacklist Network attack warning Packet capture System logs |
|
Mobile functions | |
GSM frequency | 850/900/1800/1900MHz |
WCDMA Frequency | 850/1900MHz, 850/2100MHz, 900/2100MHz |
4G LTE band | Depends on module type |
Carrier selection | Automatic/Manual |
VoLTE, if supported by your operator Send and receive SMS messages Send bulk SMS messages SMS center Gain control USSD PIN modification Call time alert Caller identification/CLIR Open API for SMS and USSD |
|
Network and management | |
Network protocol | FTP, TFTP, HTTP, SSH |
NAT Traversal | Static NAT, STUN |
Static route OpenVPN Firewall VLAN QoS/ToS DDNS Backup/restore configuration Firmware upgrade over HTTP/TFTP Web-based configuration |
|
Physical properties | |
Dimensions | 213 mm x 160 mm x 44 mm |
Power supply | AC 100-240V |
Operating temperature | 0°C to 40°C 32°F to 104°F |
Storage temperature | -20°C to 65°C -4°F to 149°F |
Humidity | 10-90% non-condensing |
No, Yeastar TG400 supports "hot swapping" of SIM cards, so there is no need to turn off or restart the device when swapping SIM cards.