Cambium EPMP 3000L EU | Access point | 5GHz 2x2 MIMO, RJ45 1000Mb/s
CODE: C050910A223A
Contact
Account
Favorite
Cart
ePMP 3000L is a third generation access point (AP) that uses interference immunity mechanisms, emphasizing high performance in low point density point and multipoint sectors. The ePMP 3000L has a 2x2 MIMO connector and can support a variety of implementations, including 90/120 degree sectors, narrow-sector corners and even 360 degree coverage in the universe. Cambium 3000L provides TDD synchronization via GPS. .
The ePMP 3000L system boasts a high throughput of packets per second and supports subscriber modules with a peak throughput of up to 600 Mb/s. Cambium ePMP device operates in the Gigabit Ethernet 10/100/1000 Mb/s standard.
| SPECTRUM Cambium ePMP | |
| Channel spacing | Configurable in 5 MHz increments |
| Frequency range | 4910 - 5970 MHz (exact frequencies permitted by local regulations) |
| Channel width | 20 | 40 | 80 MHz |
| Ethernet interfaced | 100/1000BaseT, rate negotiated automatically |
| Physical layer | 2x2 connectorized despite access |
| INTERFACE | |
| MAC addresses | Cambium Proprietary |
| Supported power supply methods | 29 V Cambium POE (included) |
| VLAN | 802.1Q with priority 802.1p. |
| Network management | HTTPS, SNMPv2c, SSH |
| Protocols to be applied | IPv4/IPV6 , UDP, TCP, IP, ICMP, SNMPv2c, HTTPS, STP, SSH, IGMP Snooping |
| PERFORMANCE | |
| ARQ | Yes |
| Nominal receiving sensitivity 80 MHz channel | MCS0 = -84 dBm for MCS9 (256QAM-5/6) = -59 dBm |
| Modulation levels | MCS0 (BPSK) to MCS 9 (256 QAM 5/6) |
| Nominal receiving sensitivity 20 MHz channel | MCS0 = -89 dBm to MCS8 (256 QAM-3/4) = -66 dBm |
| Nominal receiving sensitivity 40 MHz channel | MCS0 = -87 dBm for MCS9 (256QAM-5/6) = -64 dBm |
| LINK BUDGET | |
| GPS Sync | Yes, via internal GPS or Cambium Sync (The internal GPS receiver also includes a patch antenna and can be used without an external circulating antenna) |
| Antenna | 90/120 Degree 2X2 Sectoral antenna (C050900D021B) Available |
| Quality of Service | Three priority levels (voice, high, low) with DSCP, COS, VLAN ID, IP & MAC Address, Broadcast, Multicast and Station Priority, MIR/CIR support |
| Transmission power range | 0 to +29 dBm (total, up to regional EIRP limit) (1 dB interval) |
| Sectoral antenna connection | 2 x 50 ohms, RP (reverse polarity) SMA Also compatible with RF Elements Twistport™ adapter for ePMP |
| PHYSICAL FEATURES | |
| GPS antenna connection | 1 x 50 ohms, RP (reverse polarity) SMA; optional external Puck GPS antenna model available as N000900L030A |
| Surge suppression | 1 joule integrated. C00000000L065A - 30V Gigabit Surge Protector Recommended for optimal surge protection. |
| Environmental | IP67 |
| Energy consumption | 12 watts |
| Weight | 0.7 kg (1.5 lbs) without supports |
| Input voltage | 30 Volts Normal (14V to 30V Range) |
| Temperature | -22°F to +140°F (-30°C to +60°C) |
| Dimensions (L x W x H) | 22.2 x 12.4 x 4.5 cm (8.75 x 4.9 x 1.75 inch) without supports |
| SAFETY | |
| CERTIFICATES | |
| Encryption | 128 bits AES (CCMP mode) |
| FCCID | Z8H-89FT0047 |
| INDUSTRY CANADA | 109W-0047 |
| CE | EN 301 893 V2.1.1 (5.4 GHz), EN 302 502 V2.1.1 (5.8 GHz) |
Sync GPS ePMP Radio with built-in GPS contains two flash memory banks, each containing a software version. The version of the software version recently installed on the flash memory device (using software update procedures) is configured in the Active Bank. This software will be used by the device after restarting the device. The Inactive Software Bank will be used by the device if the active bank cannot be used due to a failure.
The ePMP series provides an adaptive modulation scheme in which the receiver constantly monitors the quality of the received signal and informs about the remote end of the link of the optimal modulation mode that can be transmitted. In this way, optimal performance is achieved at all times.
Synchronization Hold-off Timer is configurable (range: 20 - 86400 seconds). After this time, the wireless radio transmitter will switch off. However, if the sync eu GPS is set before this time has elapsed, the access point will resume normal operation.
