ePMP 3000L is a third generation access point (AP) that uses interference immunity mechanisms, emphasizing high performance in sectors from low density point to multipoint. The ePMP 3000L has a 2x2 MIMO connector and can support a variety of implementations, including 90/120 degree sectors, narrow sector corners and even 360 degree coverage in the universe. Cambium 3000L provides TDD synchronization via GPS.
The ePMP 3000L system boasts a high throughput of packets per second, supporting subscriber modules with a peak throughput of up to 600 Mb/s. Cambium ePMP device operates in Gigabit Ethernet 10/100/1000 Mb/s standard.
| Features / filters | |
| LAN standard | Gigabit Ethernet 10/100/1000 Mb/s |
| Maximum wireless transmission speed | 600 Mb/s |
| Number of LAN ports | 1x 10/100/1000BaseTX (RJ45) |
| Operating frequency | 5 GHz |
| Antenna gain | 11dBi - 20dBi |
| Device type | Access point |
| Horizontal beamwidth | 90°, 120°, |
| MIMO Type | 2x2 |
| Region / power Cable | ROW/EU |
| Type of device power supply | Passive PoE |
| Spectrum Cambium ePMP | |
| Channel spacing | Configurable in 5 MHz increments |
| Frequency range | 4910-5970 MHz (exact frequencies permitted by local regulations) |
| Channel width | 20 | 40 | 80 MHz |
| Interface | |
| MAC addresses | Ownership of Cambium |
| Physical layer | Connectorized 2x2 MIMO access |
| Ethernet interfaced | 100/1000BaseT, rate negotiated automatically |
| Supported power supply methods | 29 V Cambium PoE (included) |
| Protocols to be applied | IPv4/IPV6, UDP, TCP, IP, ICMP, SNMPv2c, HTTPS, STP, SSH, IGMP Snooping |
| Network management | HTTPS, SNMPv2c, SSH |
| VLAN | 802.1Q with priority 802.1p |
| Performance | |
| ARQ | Yes |
| Nominal receiving sensitivity 20 MHz channel | MCS0 = -89 dBm to MCS8 (256 QAM-3/4) = -66 dBm |
| Nominal receiving sensitivity 40 MHz channel | MCS0 = -87 dBm for MCS9 (256QAM-5/6) = -64 dBm |
| Nominal receiving sensitivity 80 MHz channel | MCS0 = -84 dBm for MCS9 (256QAM-5/6) = -59 dBm |
| Modulation levels | MCS0 (BPSK) to MCS 9 (256 QAM 5/6) |
| GPS Sync | Via internal GPS or Cambium Sync (the internal GPS receiver also includes a patch antenna and can be used without an external circulating antenna) |
| Quality of Service | Three priority levels (voice, high, low) with DSCP, COS, VLAN ID, IP & MAC Address, Broadcast, Multicast and Station Priority, MIR/CIR support |
| Link Budget | |
| Antenna | 90/120 Degree 2X2 sector antenna (C050900D021B) available |
| Physical characteristics | |
| Sectoral antenna connection | 2 x 50 ohms, RP (reverse polarity) SMA. Also compatible with the RF Elements Twistport™ adapter for ePMP |
| GPS antenna connection | 1 x 50 ohms, RP (reverse polarity) SMA, optional external Puck GPS antenna model available as N000900L030A |
| Surge suppression | 1 joule integrated. C00000000L065A - 30 V Gigabit surge protector recommended for optimal surge protection |
| Environmental | IP67 |
| Transmission power range | 0 to +29 dBm (total, up to regional EIRP limit) (1 dB interval) |
| Temperature | -30°C to 60°C (-22°F to 140°F) |
| Energy consumption | 12 W |
| Input voltage | 30 V normal (14 V to 30 V - range) |
| Weight | 0.7 kg (1.5 lbs), without supports |
| Dimensions (L x W x H) | 22.2 x 12.4 x 4.5 cm (8.75 x 4.9 x 1.75 inch), without supports |
| Security | |
| Encryption | 128 bits AES (CCMP mode) |
| Certificates | |
| FCCID | Z8H-89FT0047 |
| Industry Canada | 109W-0047 |
| CE | EN 301 893 V2.1.1 (5.4 GHz), EN 302 502 V2.1.1 (5.8 GHz) |
Sync GPS ePMP Radio with built-in GPS contains two flash memory banks, each containing a software version. The flash memory software version that was last installed on the device (using software update procedures) is configured in Active Bank. This software will be used by the device after it is restarted. On the other hand, an inactive bank of the software will be used by the device in case the active bank cannot be used, e.g. due to a failure.
The ePMP series provides an adaptive modulation scheme in which the receiver continuously monitors the quality of the received signal and informs about the remote end of the link of the optimal modulation mode that can be transmitted. In this way, optimum performance can be achieved at all times.
Synchronization Hold-off Timer is configurable (range: 20 - 86400 seconds). After this time, the wireless radio transmitter will switch off. However, if the sync eu GPS is set before this time has elapsed, the access point will resume normal operation.
