EN
Mikrotik RB850Gx2 is a five-port Gigabit Ethernet router. Compared to RB450G, RB850Gx2 is much faster, with a dual-core processor, but still retains the same form and will fit into the same chassis. The device is powered by a 500MHz P1023 PPC processor and also includes a temperature sensor and voltage monitor.
Features / filters | |
Number of LAN ports | 5x 10/100/1000BaseTX (RJ45) |
Additional connectors / interfaces | 1x microSD |
CPU frequency | 500MHz |
Management | CLI - Command Line Interface, By web browser, |
PoE input | Yes |
RAM memory | 512MB |
Type of case | Without enclosure |
Type of device power supply | Passive PoE, Power supply, |
Basic technical parameters | |
CPU frequency | 500 MHz |
Number of CPU cores | 2 |
Number of RAM | 512 MB |
Architecture | PowerPC |
10/100/1000 Ethernet ports | 5 |
MiniPCI | 0 |
MiniPCI-e | 0 |
Wireless IC model | None |
USB ports | 0 |
Memory card | 1 |
Type of memory card | microSD |
Jack power supply | 2 |
802.3af | No |
PoE out | No |
PoE in | Yes |
Supported input voltage | 5 V - 30 V |
Voltage monitor | Yes |
CPU temp monitor | Yes |
PCB temperature monitor | Yes |
Dimensions | 90x115mm |
System | RouterOS |
Licence level | 5 |
DBi antenna gain | No |
Current monitor | No |
Maximum power consumption | 8W |
Ports SFP | 0 |
Ports SFP+ | No |
RouterBOARD is a hardware platform from MikroTik, which is a line of routers with RouterOS operating system. Almost all models of RouterBOARD devices can be powered via Ethernet (PoE) and have a connector for external power source.
Look for the reset button marked "RES" on the MikroTik router. Then turn off the power to the device. Hold down the reset button and do not release it. Turn on the device power and wait for the "ACT" LED to flash. Finally, release the button to clear the configuration.
Each router is configured at the factory with IP address 192.168.88.1/24 on Ethernet port1. The default user name is admin without password. After the first login, please create a new user with the password in the "full" group, log in again and remove the default admin user.