Tinycontrol 1SFP10G | Switch | PoE, 10x RJ45 1000Mb/s, 1xSFP
CODE: POESWG-101 SWITCH POE 1SFP10G
Contact
Account
Favorite
Cart
The Tinycontrol 1SFP10G is a unique combination of managed switch, high performance PoE injector and I/O controller. Unlike typical devices, it does not have a fixed output voltage. This parameter depends on the supply voltage. In addition, it has 2 independent power sections, each of which can be powered from 12-55V, achieving the same voltage at the PoE output.
All power parameters for the entire switch and each port are controlled remotely, including a Watchdog feature that resets port power in the event of an ICMP (ping) failure, allowing you not to be physically near the device during setup and configuration.
The switch is compatible with the so-called passive PoE standard. All PoE outputs can be remotely monitored for power and current consumption, as well as connection status and speed on Ethernet ports, which is very useful for prioritizing traffic flow.
| Basic general data | |
| Manufacturer | Tinycontrol |
| Model | 1SFP10G |
| Type | Switch |
| Ports | 10 1000/100/10 Mbit ports 1 SFP port 1 Gbit |
| Inputs | 1 logic input 1 transistor output |
| PoE standard | Passive - powered through all pairs of wires |
| Supply voltage | 2 x 9-57V |
| Maximum current per 1 PoE port | 750mA |
| Maximum current on all ports | 2 x ≤6A |
| Power consumption | <1W (with one active link) |
| Protection against reverse polarity of the power supply | Yes |
| Maximum current of the transistor output | 1A |
| Operating temperature range | -20 to 85 °C |
| Weight | 1kg |
| Housing type | Desktop or rack |
| Dimensions | 250 x 102 x 37mm (without handles), 450 x 102 x 37mm (with brackets), Occupies 1U |
| Basic properties | Management via WWW or SNMP v2 Firmware update remotely via TFTP Real time data readout without page refresh Possibility to switch 10 PoE ports directly from WWW page IP Watchdog on each port (email notification, power reset on PoE) 2 independent power sections for 5 ports each Board ambient temperature measurement Supply voltage measurement with accuracy of -/ 0.1V Current and power measurement on each PoE port Time setting manually or by NTP server Automatic SNMP TRAP sending with value (VCC, Temp, INPD, INPA) Supported protocols: HTTP, SNMP, SMTP, SNTP, ICMP, DNS, DHCP VLAN support (option available in the future) Optional rack mounting |
| Data sheet | Download |
Yes, the switch comes with rack mounting brackets
