The Ubiquiti airMAX OMNI AMO-3G12 omnidirectional antenna increases the range and increases the transmission speed of the access point. The antenna is characterized by operation in the 3GHz frequency band. A distinguishing feature of the airMAX OMNI AMO-3G12 model is also the maximum level of antenna gain - 12dBi and a standing wave ratio (VSWR) of 1.6:1.
The AMO-3G12 antenna from Ubiquiti is a high class 2x2 MIMO antenna with dual polarity, operating in the 3GHz band and with an energy gain 12dBi. The airMAX OMNI AMO-3G12 omnidirectional antenna has been designed to integrate with the RocketM radio, with which it allows to create a powerful omnidirectional base station with 360° of signal distribution.
AirMAX antennas have a robust mechanical construction for outdoor deploymemt.
Each airMAX antenna has a built-in Rocket mount, so no additional tools are needed to install the Rocket BaseStation.
| Features / filters | |
| Antenna frequency | 3 GHz |
| Energy gain | 10dBi - 20dBi |
| Antenna gain level (max) | 12 |
| Antenna type | Omnidirectional, Sector antenna, |
| Application | Outdoor |
| Compatible with brand | Ubiquiti |
| Connector type | 2x RP-SMA |
| Cross polarization isolation | >25 dB |
| Depth | 122 |
| Electric deviation | 4° |
| Frequency band | 3.4 - 3.7 |
| Harmonized System (HS) code | 85177100 |
| Height | 84 |
| Horizontal beam width | 8 |
| Horizontal beamwidth | 360° |
| MIMO Type | 2x2 |
| Mounting | Wall |
| Polarization | Double linear, Dual polarization, |
| Purpose | Outdoor |
| Quantity per pack | 1 |
| Vertical beam width | 4 |
| Voltage Standing Wave Ratio (VSWR) | 1.6:1 |
| VSWR | 1.6:1 |
| Weight | 2.05 |
| Width | 1030 |
| Basic technical parameters | |
| Dimensions (mm) | 1012 X 122 X 105 |
| Weight | 2.05 kg |
| Frequency | 3.4 - 3.7 GHz |
| Gain | 12 dBi |
| Elevation beamwidth | 8° |
| Maximum VSWR | 1.6:1 |
| Electrical downtilt | 4° |
| Wind Survivability | 200 km/h |
| Wind load | 111.2 N @ 200 km/h |
| Polarisation | Vertical and horizontal (dual linear) |
| Insulation between the polarization | 25 dB min. |
| ETSI | EN 302 326 DN2 |
| Mounting | Universal Pole Mount, RocketM Bracket, and Weatherproof RF Jumpers Included |
1. Connect the RF cables to the sockets marked as Chain 0 and Chain 1 on the device. 
2. Adjust the brackets on the back of the housing with the mount and slide it down until it locks in place. 
3. Connect the remaining cables to the antenna. 
4. Insert four carriage bolts to the main antenna bracket. 
5. Secure the antenna to the upper part of the pole.
a. Slide the pole brackets over each pair of carriage bolts.
b. Secure each bracket using two serrated flange nutsZabezpiecz każdy zacisk za pomocą dwóch nakrętek ząbkowanych.
c. Tighten each nut to about 25 N-m 
