![Ubiquiti UF-NANO | ONT | UFiber, 1x GPON, 1x RJ45 1000Mb/s Ilość portów LAN1x [10/100/1000M (RJ45)]](https://www.batna24.com/img2/500/293226_1.webp?20989284221)
UFiber Nano G is a rugged, high-performance GPON CPE device, equipped with an LED display and has an elegant design. The easy-to-read display provides status information about: IP address, signal strength and throughput.
Nano G is powered by a single 24 V cable, passive PoE is used to transfer both energy and data.
Up to 128 Nano G devices can be connected via a single GPON port.
| Features / filters | |
| Number of LAN ports | 1x 10/100/1000BaseTX (RJ45) |
| PON standard | GPON |
| Built-in processor | Yes |
| Certification | CE, FCC, IC |
| Data transfer rate | 2.488 |
| Dimensions (WxDxH) | 77 x 77 x 28 |
| Ethernet LAN (RJ-45) ports | 1 |
| Ethernet LAN data rates | 1000 |
| Harmonized System (HS) code | 85176990 |
| Input current | 0.3 |
| Input voltage | 24 |
| Internal memory | 128 |
| LED indicators | Yes |
| Number of processors installed | 1 |
| Numbers of pieces in the package | 1-pack |
| Operating relative humidity (H-H) | 5 - 95 |
| Operating temperature (T-T) | -10 - 45 |
| Power consumption (typical) | 7 |
| Power over Ethernet (PoE) | Yes |
| Processor frequency | 240 |
| USB port | None |
| VoIP ports | None |
| Weight | 110 |
| Basic technical parameters | |
| Dimensions | 77 × 77 × 77 × 28 mm |
| Weight | 110 g |
| Network Interfaces | (1) SC/APC, GPON WAN (1) RJ45, Ethernet LAN |
| Speed network interface | (1) GPON WAN, ITU G.984, 2.488 Gbps download, 1.244 Gbps upload (1) GbE LAN, 10/100/1000 Mbps |
| Management interface | Ethernet in the /PON band |
| Normal optical power range | TX (B+ class): 1.5 to 5 dBm. RX: -8 to -28 dBm |
| Power supply method | 24 V passive PoE (pins +4, 5; -7, 8) Dying Gasp Support |
| Power supply | PoE adapter: 24 V, 0.3 A |
| Maximum power consumption | 7W |
| Voltage range supported | 20 to 28 V |
| CPU specification | MIPS-32, 240 MHz |
| Memory | 128 MB DDR3 |
| Buttons | (1) Display of information (1) Reset |
| Operating temperature | -10 to 45° C |
| Operating humidity | 5 to 95% |
Connect the optical cable from the passive optical network to the PON port.
1. Connect the Ethernet cable to the LAN port.
2. Power the device using one of the following ways:
- By using the included Gigabit PoE adapter
- By using a separate PoE switch
Operating temperature: -10 to 45° C
Maximum power consumption 7W
